TitelLogo
High frequency analyser kit HFE59B

Gigahertz Solutions high frequency analyser kit HFE59B

  • The total exposure is being measured and displayed directly in the units of the recommended limiting values of the standard of building biology SBM (µW/m²)
  • The included logarithmic periodic antennas fully compensated and allow for pinpointing the source of EMF-pollution
  • The high resolution and long time precision is granted through also patented self-aligning circuitry elements
  • The audio analysis feature helps identifying the underlying radio services
  • The provided measurement guideline including their recommended limiting values of the standard of building biology SBM enables even technical laymen to perform a reliable assessment of the personal EMF-pollution, as well as a determination of suitable remedial actions, and a control of their effectiveness
  • Display of peak value as well as average value (switchable)

Technical data

Frequency range
27 MHz up to above 3.3 GHz
Measurement range
Power flux density: 0.001 - 1,999,000 µW/m²
 
(i.e. 1 nanoW/m² nominal display resolution to 1.999 W/m²
 
when applying the amplifier and attenuator enclosed)
Accuracy
Basic accuracy (CW) including linearity tolerance: ± 3 dB
 
Zero offset and rollover: ± 5 digits
Sensor
2 antennas:
 
Optimised logarithmic periodic antenna with frequency
 
compensation directly on the antenna: Less ripple, better directionality,
 
improved shielding vs. ground, continuous LED-monitoring
 
of quality of connections
 
Quasi-isotropic ultrabroadband antenna (\omni\-characteristic)
 
aligned for vertically polarised fields
Audio analysis
Identification of pulsed radiation sources
 
(mobile radio (GSM, UMTS/G3), cordless telephones (DECT),
 
WLAN (Bluetooth), air-traffic control radar) by means of an
 
acoustic signal proportional to the modulation frequency
Signal rating
Display of peak value, peak hold as well as average value (switchable)
 
Quantitative differentiation between pulsed and un-pulsed radiation
 
(patented control)
Signal output ports
A calibrated extra AC-measurement output for the demodulated
 
signal, and a scalable DC-output
Power supply
Rechargeable highpower 9.6 Volt NiMH battery pack inside the meter
 
Average operation time: 7 - 8 hours
 
Low-Batt. indication
 
Auto-power-off (can be deactivated for longterm measurements)
 
AC-adaptor for charging and longterm operation included

Subject to technical alterations.


Scope of delivery

High frequency analyser kit HFE59B
Art.-No. 404
Measuring device HF59B, slip-on logarithmic periodic antenna with antenna cable, attenuator with DC-bypass DG20_G10, ultra broadband antenna for RF-analysers UBB27_G3, high frequency preamplifier HV10_27G3, high pass filter HP700_G3, plastic transport case K2, detailed manual with neutral background informations